Teejet BOOMPILOT JOB COMPUTER Manual do Utilizador descarregar pdf (Página 27)

98-05210 R0 US

ISOBUS Job Computer : BoomPilot

OVERVIEWSETUPAPPENDIX GETTING STARTEDOPERATION

APPLICATION BOUNDARY

Application boundaries establish areas where application is and is not applied while using ABSC or BoomPilot.

To establish an application boundary:

Figure 4-4: Boundary in Progress

Figure 4-5: Bounded Area Coverage Status

1.77 B.area

5.2 0.0

0:00 hh:mm

mph

No GPS

1. Drive to a desired location at the perimeter of the

field/application area.

2. Press START BOUNDARY key .

3. Travel the perimeter of the eld/area.

4. Finish boundary:

►Travel to within one swath width of the starting

point. The boundary will close automatically (the

operations screen will begin showing the Bounded

Area Coverage Status in the Bounded Area Status

section).

►Press BOUNDARY FINISH key . A straight line

will complete the boundary between your current

location and the starting point

NOTE: The boundary will not be available if the minimum

distance is not travelled (five-times the swath

width).

To apply without a boundary:

1. Drive to a desired location at the perimeter of the

field/application area.

2. Press NO BOUNDARY key .

3. Begin application.

Bounded Area Coverage Status

Bounded Area Coverage Status displays the amount of

the bounded area that has had application applied to it.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Sem comentários

Teejet BOOMPILOT JOB COMPUTER Manual do Utilizador Página 27