Teejet Tilt Compensation Module Guide_SmartPad II Manual do Utilizador descarregar pdf (Página 2)

Page 2 of 2

SmartPad II Settings

Once the Tilt Sensor is properly installed and connected to the SmartPad II, two initial setup steps

must be performed; enter an antenna height and calibrate (level) the sensor. The vehicle should be on

level ground when performing these two steps.

Antenna Height

To access Antenna Height select Guidance>Setup>Guidance>Antenna Height. Enter the height of the

GPS antenna above the ground. Initial value is 9.8ft (3m). Minimum value is 0, and the maximum value

is 32.8ft. (10m).

Calibrate Tilt Sensor

Once the antenna height has been entered, and the vehicle is on level ground, the sensor needs to be

calibrated (Level). To access the level feature select Tools>Level.

Highlight the Level Tilt menu item and press the enter button. When calibration is complete a

message dialog box will appear. Press enter to continue.

Tilt Sensor System Guide

Figure 2: Setting Antenna Height

Figure 3: Calibrating (Level) Tilt Sensor

1 2

Sem comentários

Teejet Tilt Compensation Module Guide_SmartPad II Manual do Utilizador Página 2