Teejet Legacy 6000 Manual Manual do Utilizador descarregar pdf (Página 34)

Legacy 6000

98-05053 R2

Figure 2-23: Servo Settings

Table 2-9: Servo Settings

Settings Description

Gain Speed at which the Control Channel reacts to an off-target condition. Decrease to slow

down the reaction; increase to speed up reaction (settings too high can result in oscilla-

tion).

Start Up Drive Drive level used to open valve only from full closed position. Increase if valve opens too

slowly and decrease if valve opens too quickly.

Master Switch Control valve response to all booms (OFF). Master Hold - Control valve will hold in the

same position. Closed - Control valve will drive full closed.

Implement Status Control valve response to when the Implement Status switch is open (OFF). Hold - Con-

trol valve will hold in same position. Closed - Control valve will drive full closed.

Valve Delay Delay in resuming control after turning booms ON from HOLD. When the control valve is

set to close, this feature is deactivated. When Master ON, valve will delay control for the

set value.

Valve Location Location of the control valve in the plumbing (In-Line or Bypass). Combination in-line/

bypass valves like the Autorange valve and most hydraulic servos use the In-line setting.

Figure 2-24: PWM Settings

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 158 159

Sem comentários

Teejet Legacy 6000 Manual Manual do Utilizador Página 34