Teejet RX 400p Manual do Utilizador Página 46
- Página / 151
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
RX 400p
98-05044 4-4
R1
a A
No WAAS Lock WAAS Lock
Figure 4-4 WAAS Lock Icon
4.4.3 OmniSTAR Lock Icon
When operating using the internal L-band receiver as the differential source, the RX
400p receiver indicates the OmniSTAR DGPS lock status in the upper right corner of
the display. The lock symbol, illustrated in Figure 4-5, remains in the ‘No L-band’
DGPS Lock state until the receiver has acquired the DGPS satellite transmission at
which point the symbol changes to the ‘L-band Lock’ icon. The L-band DGPS
receiver will lock to the satellite signal although a valid subscription is not present
within the receiver in order to provide the facility to subscribe the receiver over the
air.
* +
No L-band Lock L-band Lock
Figure 4-5 L-band Lock Icon
Note - When using corrections from the OmniSTAR service, the GPS output of
the RX 400p will not be differentially corrected until lock has been attained on
an OmniSTAR broadcast with a subscribed receiver.
- RX 400p 1
- Copyright Notice 3
- Trademarks 3
- MID-TECH Limited Warranty 4
- List of Figures 13
- List of Tables 14
- Preface 15
- Organization 16
- Customer Service 17
- World Wide Web Site 18
- Document Conventions 19
- 1 Installation 21
- 1.3.1 Receiver Placement 22
- 1.3.3 Power Considerations 23
- 1.3.5 Grounding the RX 400p 24
- External Device 26
- 1.5 Mounting Accessories 31
- 2 RX 400p Overview 33
- 2.2 WAAS Operation 34
- 2.3 OmniSTAR Operation 35
- 2.4 Beacon Operation 36
- 2.4.2 Receiver Performance 38
- Table 2-2 Preset DGPS Mode 40
- 3 RX 400p Architecture 41
- 3.3 Applications 42
- 4 Operation 43
- 4.3 Menu Access Icon 44
- 4.4 Receiver Status Icons 44
- % & ^ 45
- 4.4.3 OmniSTAR Lock Icon 46
- 4.4.4 Beacon Lock Icon 47
- 4.4.6 Autonomous Mode Icon 48
- Figure 4-9 GPS Menu 49
- Figure 4-10 WAAS Menu 50
- Figure 4-11 OmniSTAR Menu 50
- 4.6 Start-Up Sequence 53
- 4.7.1 WAAS Mode Bar Chart 54
- 4.7.3 Beacon Mode Bar Chart 55
- 4.8 Main Menu 56
- 4.9 GPS Menu 57
- 4.9.2 GPS Satellites Menu 73
- 4.9.3 GPS Configure Menu 75
- 4.10 WAAS Menu 81
- 4.11 OmniSTAR Menu 86
- 4.12 Beacon Menu 96
- Health Code Indication 101
- 4.13 External RTCM Menu 103
- 4.14 Autonomous Menu 105
- 4.15 System Setup Menu 106
- 4.15.2 Display Format Menu 108
- 4.15.3 Baud Rates Menu 110
- 400p receiver: 113
- 4.17 Firmware Updates 116
- 5 Configuration Wizard 117
- 5.1 Start-up Sequence 119
- 5.6 Saving a Configuration 120
- RX 400p 121
- 6 NMEA 0183 Messages 123
- 6.4 SLXMon 124
- 6.5 GPS NMEA Data Messages 125
- 6.5.2 GLL Data Message 126
- 6.5.3 GSA Data Message 127
- 6.5.4 GST Data Message 128
- 6.5.5 GSV Data Message 128
- 6.5.6 RMC Data Message 129
- 6.5.7 RRE Data Message 130
- 6.5.8 VTG Data Message 131
- 6.5.9 ZDA Data Message 131
- 7 Troubleshooting 133
- 9 Appendix B - Interface 139
- 9.2 RTCM Data Output 140
- 2 TX RTCM 141
- 5 GND GND 141
- Separate GPS Receiver 141
- 3 RX RTCM 142
- External Correction Source 142
- OmniSTAR DGPS Service 143
- 10.2.2 Contacting OmniSTAR 144
- 11 Appendix D - Beacon 147
- Information 147
- Further Reading 148
- 12 Index 149
Manuais e produtos relacionados com Computadores Teejet RX 400p
Computadores Teejet LH665 VRT Manual do Utilizador
(72 páginas)
(72 páginas)
Computadores Teejet LH 500 Manual do Utilizador
(16 páginas)
(16 páginas)
Computadores Teejet LH 500 Manual do Utilizador
(6 páginas)
(6 páginas)
Computadores Teejet LH 1000 Manual do Utilizador
(16 páginas)
(16 páginas)
Computadores Teejet LH 1000 Manual do Utilizador
(1 páginas)
(1 páginas)
Computadores Teejet LH 1200 Manual do Utilizador
(28 páginas)
(28 páginas)
Computadores Teejet LH 1200S Manual do Utilizador
(28 páginas)
(28 páginas)
IKEA OV14 002-451-73 manuály
Uživatelské manuály a uživatelské příručky pro ne IKEA OV14 002-451-73.
Poskytujeme 1 manuály pdf IKEA OV14 002-451-73 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Comentários a estes Manuais