Teejet 834-P Sprayer Control Manual do Utilizador descarregar pdf (Página 11)

TECHNOLOGIES 834-P Sprayer Control

11 98-70028-R0

System Setup Mode (GPT mode)

The System Setup Mode contains the programming steps that customize the controller to the

sprayer or sprayer components. These include calibration steps and parameters that, once

programmed, are not likely to change.

To enter the System Setup Mode:

First be sure that the console is ON (if not turn it on by pressing the key and wait

until the normal display is visible).

Ensure the Master boom switch is OFF.

Then press and hold the key for 3 seconds to enter the Program Mode.

OPERATING MODE

The 834-P can operate in either of two modes. They

are GPT (gallons per ton), used for pre-wetting

applications, or GPA (gallons per acre)used for

agricultural or anti-icing applications.

Use the

keys to adjust this value. Once

the correct mode has been selected, press

the key to advance to the next step. If

operating in GPA mode, skip ahead to page 14.

MINIMUM RPM

The 834-P can be set to automatically switch off the

flow of liquid when the salt/sand auger shaft slows

below a minimum speed. This feature prevents

liquid from being applied when the salt/sand

spreader is switched off.

Use the

keys to adjust this value to the

shaft RPM below which the pre-wetting spray should

be switched off.

tip

select

GPA

GPT

SPEED

RPM

PSI

Inch

lbs/rot

PROGRAM MODE push 3 sec.

GPT

Gal/min

@40 psi

P/300ft

P/rot

MPH

RPM

min

0.0

tip

select

GPA

GPT

SPEED

RPM

PSI

Inch

lbs/rot

PROGRAM MODE push 3 sec.

Gal/min

@40 psi

P/300ft

P/rot

MPH

RPM

min

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Comentários a estes Manuais

Sem comentários

Teejet 834-P Sprayer Control Manual do Utilizador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Computadores Teejet 834-P Sprayer Control