Teejet TASC-6100 Manual do Utilizador descarregar pdf (Página 23)

2-7

98-05018

CE & StandardVersion

TASC 6100

Setup

& Cal.

G. Stop the vehicle at the measured distance end marker.

Compare the distance indicated by the console to the

actual measured distance, to determine how much

correction is necessary. For example: if the indicated

distance is 396 Ft. after driving over a 400 foot

range, the error in the distance calibration is 1.0%.

H. Calculate the new distance calibration number using

the following formula:

Example:

NOTE: Use the same equation, regardless of the type of

distance sensor .

I. Enter the corrected cal. # using the switch settings

shown in the “GENERAL CONSIDERATIONS AND INITIAL

CALIBRATION NUMBERS” section above. Switch back to

the OPERATE mode. The distance accumulator

should now agree with the measured distance that

you traveled. If it doesn't , recheck your calculations.

RECORD THIS CALIBRATION NUMBER

LAST PAGE OF MANUAL.

SETTING THE HOLD/CLOSE RESPONSE OF THE FLOW

CONTROL VALVE

he operator can select a "Hold" or "Close" response

of the flow control valve to both “Implement

Status switch” and “All Booms OFF" conditions.

These responses are independent of each other, allowing

the operator to select a "Hold" condition for one and a

"Close" for the other. Careful consideration should be

given to both conditions and the response selected for

your application.

Implement Status Switch

When the operator selects the "Hold" condition, deactiva-

tion of the Implement Status switch (open circuit) hold’s

the flow control valve in its current position. When

Measured distance

Indicated distance

x Old DC# = New DC#

400

396

x 760 = 768, the New DC#

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 85 86

Comentários a estes Manuais

Sem comentários

Teejet TASC-6100 Manual do Utilizador Página 23

Comentários a estes Manuais

Manuais e produtos relacionados com Computadores Teejet TASC-6100